Service Updates
Please click each service update below to download a PDF with more information.
Conveyor Motor Failure
- Models affected: Traditional BR Harvesters
Improved Ground Speed/Foot Count Sensor
- Models affected: BR and SR Series Harvesters
Purging Air from the Fuel System
- Models affected: AR and SRA Harvesters
Timing the Cutter Heads
- Models affected: All Models Equipped with Anti-Vibration heads
Rotary Position Sensor (RPS) Initial Setup
- Models affected: AR and SRA Harvesters
Redesigned Cutter Head Belt Tensioner
- Models affected: All Magnum Harvesters Equipped With Timed Cutter Heads
Chop Mechanism Linkage
- Models affected: SR, SRA and AR series Harvesters
Conveyor Belt Reinforcing Clips
- Models affected: SR, SRA and AR series Harvesters
Cavity Plug Leakage
- Models affected: SR series Harvesters
Improved Hydraulic Cylinder Mounting Bushings and Pins for Second Conveyor and Net Feed Valve Adjustment
- Models affected: SR, SRA, and AR series Harvesters
Chop Mechanism Will Not Return to Up Position
- Models affected: SR, SRA, and AR series Harvesters
Cutter Head Spacers
- Models affected: SR, SRA, and AR series Harvesters
Net Dispenser Motor Leakage
- Models affected: SR, SRA, and AR series Harvesters
Cutter Head Speed
- Models affected: BR, SR, SRA, and AR series Harvesters
Increaser Maintenance
- Models affected: All models equipped with a two-stage hydraulic pump and Brevini increaser
Fine Tuning Magnum Counter Speed/Distance Calibration
- Models affected: Magnum Counter and Magnum II Counter
Counter Will Not Exit HOLD Mode (unit fails to register distance)
- Models affected: BR and SR Models
Flow Controls Seizing or Hard To Turn
- Model affected: All SR, SRA and AR units
Brevini and Young Increaser Identification
- Models affected: All models equipped with a tandem-pump hydraulic system
Checking Lug Nut Tightness
- Models affected: M-Series Big-Roll Installer
Installing Orifice in the Hydraulic Clamp Circuit
- Models affected: M-Series Big-Roll Installers
Proper Procedure To Tie Down The Machine For Transport, Netting Tangled Around Wheel Motor Shafts, and Control Lever Rod End Lubrication
- Models affected: All M-Series Big-Roll Installers
Possible Short Circuit at Battery Positive Cable and Hold-Down Clamp
- Models affected: All M-Series & A-Series Big-Roll Installers
Cutter Head Belt Replacement, Driveshaft Replacement, and Driveshaft Universal Joint Breakage
- Models affected: All Harvesters Equipped With Timed Cutter Heads